Prior to resting or when we leave, we should kill the fireplace and close the entryway
(ξυλα για τζακι)
Indications of a glitch
Poor shot : The shot is the current of air that causes the discharge and that makes the smoke ascend through the chimney. In the event that this is lacking, the chimney causes a ton of smoke in the room in light of the fact that the gases don't stream appropriately.
The principle capacity of a chimney is to make a decent burning and transport the gases of said ignition out.
A high chimney gives a more noteworthy draft: if this is inadequate, an answer can be to make it higher.
On the off chance that the print run isn't settled, one more of the issues that emerge, notwithstanding smoke shaping in the room, is the amassing of sediment in the cylinder.
Gathering of sediment:
It is the outcome, as we have stated, of a deficient ignition of the wood, the issue that has not completed the process of burning by any stretch of the imagination.
It happens particularly when the wood is green and of lower quality, for example, pine. Residue collects on the dividers of chimneys and the channels that convey smoke.
It is exceptionally combustible and, in the event that it collects in adequate amounts, at high
temperatures breaks may frame on the dividers. This issue is normally observed when parts of the dividers start to fall through the course.
Different components:
A similar chimney can act in various courses relying upon components, for example, climatic weight, the temperature of the house, the level of opening of the air bays,
the situation of the rooftop, the stature of the pipe, the activity of the breeze or the level of aggregated earth.
It might appear to be basic or cliché, yet turning on the fireplace is critical to maintain a strategic distance from issues, for example, the arrangement of a billow of smoke in the room.
The main thing that must be done is to expel the amassed fiery remains and clean the glass of the entryway.
The key is to utilize chips , without over-burdening so as not to suffocate it, and with the point of framing flares, which are those that produce tourist,
also, this is the one that hauls the smoke out. We will utilize fine wood or dry pineapples or pills to light, however not combustible fluid or gel; to consume as fuel we will utilize thicker firewood.
Prior to including the fine wood, we will hold up until there are flares so as not to suffocate the fire. It must be done in a stunned manner, enabling the firewood to consume,
until achieving the thickest trunks. On the off chance that more firewood is presented than would normally be appropriate, we will have more smoke that calls since it isn't producing enough warmth.
The smoke needs the chimney pipe to be hot to circle through it, and this is accomplished with flame.
Once accomplished, the speed at which we need the wood to consume must be controlled. For this, the diverse shooters will be utilized that enable us to
control the printing